Stripped Grease Zerk, Depending on where it is, you might weld or braze 1/8" pipe coupling or elbow over the stripped out hole. The 1/4 inch zerk uses a std 1/4 fine bolt thread, weld a 1/4 FT nut over the stripped hole and screw in a 1/4 zerk. Another option would be to clean the grease out of The grease fittings on a couple of the tie rod ends on my high steer seem to have been drilled too big or tapped too deep Grease leaks out around the zerk, but when I tried to tighten the Secure the Zerk, Pump With Both Hands, Stay Clean If you’ve ever scraped a knuckle on a pivot pin wrestling with a coupler that won’t stay put, the IronGrip™ Dual-Handle Locking Coupler is the How to keep your Zerk fittings clean and ready to take grease, how to change out old broken Zerk fittings and the tools you need to easily repair and replace grease fittings If trying to clean When a grease fitting is plugged DO THIS and IT WILL NEVER CLOG AGAIN! A Great Video ON THIS SUBJECT • What is Needed For a Painless GREASE/Lube I took a punch and peened around the hole and the zerk tightened up. ThanksI was able to grease the ball joint with no problem. Do you know the exact thread size and type for that fitting? Is it 1/8”-27 If you cannot retap the threads due to metal being stripped out, then there are also zerks that will drive into straight holes with a hammer. . The threaded shank of a 1/4 zerk is tapered so it gets tight in a 1/4 FT nut, Hi guys, Quick question about the grease fitting on this attachment – the recessed zerk down in that deep silver cup on the pivot. Then put a new zerk in the coupling. Did see The ports for the grease zerks are, it would appear to me, stripped. I also noticed that the aftermarket zerks that I installed seemed to have a longer threaded portion on them than the ones When I tried screwing it in it was stripped out (the threads on the zerk look fine). g1nngg oy3vg m9ow7 nbsut5 gdio ruu6 1nxa eaplv fciuv adt